Research & Insights
Dried Brewer's Yeast from Vietnam: 2026 CoA Results and How to Read Them
Published

In short: An independent laboratory analysis of a TBESBY lot in September 2026 measured 43.1% crude protein, 6.4% moisture and 4.8% ash. All three sit inside the contract specification of 40–46% protein, below 10% moisture and below 6% ash. Aflatoxin B1 was below the 1 ppb quantification limit, Salmonella was not detected, and every heavy metal tested was below the EU maximum level for feed materials.
This page is for feed and pet food buyers who compare dried brewer's yeast from Vietnam on documents before they order a sample. It sets out the 2026 results, puts each figure next to the reference value a buyer would use, and lists what to ask for on a lot-specific certificate of analysis (CoA).
What did the 2026 analysis measure?
The sample was inactive, drum-dried Saccharomyces cerevisiae, made from fresh brewer's yeast at our own facilities in Vietnam. Results are on an as-received basis and describe one representative sample.
| Parameter | 2026 result | TBESBY specification |
|---|---|---|
| Crude protein | 43.1% | 40–46% |
| Moisture | 6.4% | Below 10% |
| Crude ash | 4.8% | Below 6% |
| Crude fat | 0.5% | Not specified |
| Crude fiber | <0.5% | Not specified |
| Total amino acids | 36.4% | Not specified |
| Lysine | On request | 30.5 g/kg |
| Threonine | 20.5 g/kg | Not specified |
| Vitamin B1 / B2 / B3 | 49 / 19 / 132 mg/kg | Not specified |
Moisture changes how the protein figure compares with published data. At 6.4% moisture, 43.1% crude protein as received equals 46.0% on a dry matter basis. Feedipedia's brewers yeast datasheet gives an average of 48.9% crude protein in dry matter, from 108 analyses with a range of 39.3–56.8%. The 2026 result sits well inside that range. The low moisture also leaves a margin under the 10% maximum, which supports the 12-month shelf life.
Ash follows the same logic. 4.8% as received is 5.1% of dry matter, against a Feedipedia average of 7.0%. Lower ash means less mineral load to account for in recipes with tight calcium limits, such as large-breed puppy food.
How does the amino acid result compare with the literature?
Total amino acids measured 36.4% of the product. Threonine is a useful cross-check. Feedipedia lists threonine at 4.4% of crude protein, which predicts 19.0 g/kg at 43.1% protein. The lab measured 20.5 g/kg, close to and slightly above the prediction. The full literature matrix and the as-fed conversion are in our brewer's yeast amino acid profile.
Glutamic acid was the largest single amino acid at 4.83 g per 100 g, followed by aspartic acid at 3.84 g. Both contribute to the savoury taste that makes brewer's yeast useful in pet food and aquafeed. More on that in what brewer's yeast tastes like.
How do mycotoxins, heavy metals and microbiology compare with EU limits?
| Test | 2026 result | EU maximum for feed materials |
|---|---|---|
| Aflatoxin B1 | Below 1 µg/kg (LOQ) | 20 µg/kg |
| Ochratoxin A, DON, fumonisin | Not detected | Guidance values only |
| Lead | 0.06 mg/kg | 10 mg/kg |
| Arsenic | 0.93 mg/kg | 2 mg/kg |
| Mercury | Not detected | 0.1 mg/kg |
| Cadmium | Not detected | Set by feed material class |
| Melamine | Not detected | 2.5 mg/kg |
| Salmonella | Not detected | No harmonised limit; buyers usually require absence in 25 g |
| E. coli | <10 CFU/g | No EU feed limit |
| GMO screening (CaMV 35S, NOS) | Not detected (LOD 0.1%) | Labelling threshold 0.9% |
Maximum levels for aflatoxin B1, lead, arsenic, mercury, cadmium and melamine come from Directive 2002/32/EC on undesirable substances in animal feed. Ochratoxin A, deoxynivalenol (DON) and fumonisins have guidance values under Commission Recommendation 2006/576/EC rather than legal maximums. EU limits refer to feed with 12% moisture. Recalculated to that basis, the TBESBY results fall by about 6%, so the margins are slightly wider than the table shows.
Who tested the product?
The 2026 typical analysis was run by an independent ADM laboratory. The product has also been tested by SGS, and GMO screening was done at a VILAS-accredited laboratory under ISO 21569. TBESBY holds US FDA registration, and dried brewer's yeast production is certified to ISO 22000:2018. Reports and certificates are on our quality and certificates page, and full reports are available on request.
What should a lot CoA from a Vietnam supplier include?
A typical analysis shows what a product can do. A lot CoA shows what was shipped. Before the first container, agree that each lot CoA carries:
- A lot number and production date that match the bag labels and shipping documents.
- The basis for each nutrient, as received or dry matter.
- Crude protein, moisture and ash, with the test method.
- Aflatoxin B1 with the quantification limit stated, and Salmonella.
- Heavy metals when the destination is the EU or UK.
- The laboratory name and its accreditation.
Our guide on how to read a brewer's yeast CoA walks through each line, and importing brewer's yeast from Vietnam covers the HS code and shipping documents.
Why does a current CoA matter?
Literature averages describe brewer's yeast in general. Yeast strain, brewing recipe and handling before drying all move the figures. A drum-dried product made from yeast collected at the same breweries month after month varies less than the literature range, and a dated analysis lets a formulator replace table values with current ones. To check a specific lot, request a lot CoA or a sample for your own analysis.
Frequently asked questions
Is TBESBY dried brewer's yeast from Vietnam tested by an independent laboratory?
Yes. The 2026 typical analysis was run by an independent ADM laboratory. The product has also been tested by SGS, and GMO screening was done at a VILAS-accredited laboratory. Full reports are available on request.
What protein level does the 2026 CoA show?
43.1% crude protein as received, which is 46.0% on a dry matter basis. The contract specification is 40–46% crude protein.
Does TBESBY dried inactive brewer yeast meet EU limits for aflatoxin and heavy metals?
In the 2026 analysis, aflatoxin B1 was below the 1 µg/kg quantification limit against an EU maximum of 20 µg/kg. Lead (0.06 mg/kg) and arsenic (0.93 mg/kg) were below the EU maximums of 10 and 2 mg/kg. Mercury, cadmium and melamine were not detected.
Can I get a CoA for the lot I am buying?
Yes. Each shipment can be supplied with a lot CoA that carries the lot number, protein, moisture, ash and safety results. Ask for it with your quotation.